New Posts  All Forums:

Posts by meledmonds

Thanks Leah...thats what I figured but wanted to verify
Hi everyone! After reading tons of post here, I decided to go with the SPS tacker plates and flat dowel system. I have stack cake that I just measured and my SPS plate supports will not go all the way down the bottom layer; essentially the bottom layer is taller than the supports / plate. Is this normal????? Will my top layer be supported appropriately even though the supports do not extend to the bottom of the supporting layer? TIA!
Hi everyone!After reading tons of post here, I decided to go with the SPS tacker plates and flat dowel system. I have stack cake that I just measured and my SPS plate supports will not go all the way down the bottom layer; essentially the bottom layer is taller than the supports / plate. Is this normal????? Will my top layer be supported appropriately even though the supports do not extend to the bottom of the supporting layer? TIA!!!!!!
New Posts  All Forums: