How to Make Gumpaste Baby Shoes for a Baby Shower Cake

gumpaste-baby-shoes-tutorial

I have finally finished my baby shoes tutorial! I first began making these shoes using MMF, but found that gumpaste was a better solution, and more successful

Supplies

baby-shoes-template

 

1. Trace shoe template onto parchment paper over cardboard, and cut out the template pieces.

ohje1

2. Roll out the blue gumpaste to about 2.5 mm thick, and cut out parts 1, 2 and 3 using the baby shoe template as your guide

ohje2

3. Make a stitched pattern and 6 holes on the edge of part 1 from the template. You can use a toothpick and a quilting wheel to get the desired look.

ohje3

4. Make a small ball shape in the “toe” area of the soles of the baby shoe (part 3 on the template). This will act as a support for the next step.

ohje4

5. Brush the edge of the baby shoe with gumpaste glue or water, and attach part 2 from the template over the ball of gumpaste. Leave a 2.5 mm space on both side for the next step.

ohje5

6. Brush the edge of the baby shoe with gumpaste glue, and attach part 1 to the back part of the baby shoe

ohje6

7. The shoe is basically done now. We just need to add some accessories. For this tutorial I have used a small ribbon, but you could also use thin ropes of gumpaste made using an extruder. Weave the ribbon through holes in the gumpaste gently in the same way you would lace up a real shoe. You can use a pair of forceps or tweezers if your shoe is very small. Once laced up, gently push together the sides of the gumpaste, so it curves naturally and the total shoe is about 30 cm wide

ohje7

8. To finish the shoe, cut parts 4, 5 and 6 from thin white gumpaste.

ohje8

9. Apply gumpaste glue to the tip of the shoe. Press the white gumpaste onto the tip, and the trim the excess.

ohje9

10. Apply gumpaste glue t the bottom sides of the shoe all the way around, and press part 6 onto the sides. You may wish to add a ribbed texture to this piece.

ohje11

11. Add stitching to part 5, and using a little bit more gumpaste glue, attach it to the very back of the baby shoe vertically. This creates the back strap.

ohje10

12. You can then cut out little stars and circles, or any other embellishments to add to the side of the baby shoes. Allow everything to dry, and you are ready to place on your baby shower cake!

ohje12

Follow steps 1-12 again for the other shoe, but be sure to make a mirror image, so you have proper “left” and “right” shoes.

ohje13

miika1

23 Responses to “How to Make Gumpaste Baby Shoes for a Baby Shower Cake”

    • If you save the full size version (by clicking on the image in the tutorial) it should print true to size, however you can shrink/enlarge it based on the exact size of shoe you are wanting to create. Use PART 3 on the template (the soles of the shoes) to measure how large/small you want your final shoe to be.

  1. I saved the template to my desktop. I printed it from there, but it cut off the right 2/3 of piece 2. I then saved it to a word doc (set on landscape) printed it & it printed teeny. I enlarged it to 125% & 150%. What a round about way to do things, but I got it. Sucess at last !!!

Leave a Reply